Wireless door lock actuator CFA3000S (Art. no. 10124)

  • For house and flat entrance doors, office and service rooms
  • Easy to use: lock/unlock and open the door by pressing a button
  • For assembling on the internal side of the door

Wireless door lock actuator CFA3000S (Art. no. 10124)


  • No special cylinder required – integration into existing lock system possible
  • Designed for Euro profile cylinders according to DIN 18252 and DIN EN 1303 with emergency function
  • Easy, flexible and wireless installation: clamp, glue or screw
  • Fully automatic programming of the central unit
  • Intelligent motor controller
  • Maximum security due to AES-128 bit encryption
  • Power supply by battery (4 x AA batteries included)
  • Cylinder protrusion of 7–12 mm required on the inside of the door


  • Colors: silver, white
Technical drawing
Art. no.: 10124
Article group: 20
No. of keys supplied: without key
Packaging: single carton
Weight: 538 g
color: silver
Wireless door lock actuator CFA3000S
Art. no. 10124

Packaging: single carton
Weight: 538 g
Wireless door lock actuator CFA3000W 
Art. no. 10123

Packaging: single carton
Weight: 543 g

We recommend that you do not dispense with the mechanical locking option from the outside so that it is still always possible to use a normal key here in an emergency (battery fault, failure, etc.).
The locking cylinder must therefore also have an emergency and hazard function. If you were to power an ABUS reinforced lock bar using HomeTec Pro, this use would not be approved by ABUS.

Yes, the beep tones can be adjusted or even switched off using the wireless keypad.

Yes, where the door can be locked in the usual fashion using a key, HomeTec Pro can be used.

It varies greatly depending on the conditions on site (interior and exterior walls, etc.), as is generally the case with wireless technology. Around ten metres is the maximum range possible.

The typical life of a new set of high-quality batteries is up to two years in the keypad and up to one year in the door lock power unit and the remote control.

Please note: The way it is used is of course also a factor – the more often it is used, the more often the batteries will need changing.

All four dead batteries must first be removed and replaced with new batteries (AA batteries). If the old batteries are changed one at a time, the notification is not reset.

Questions & answers

Security glossary